2021年9月6日月曜日

JBL 2235H ウルトラスエードエッジ交換、JBL 4333B用ネットワーク作業の紹介 JBL 2235H Ultrasuede surround replacement and JBL 4333B crossover works

ケンリックサウンドの熊木です。本日のケンリックサウンドで行われている作業を紹介いたします。
Hello, this is Kumaki from Kenrick Sound. I will post some of our work today.


こちらはユニット単体での修理を承っているJBL2235Hのウルトラスエードエッジ交換作業です。ボイスコイルのセンター出しをしている様子です。
This is a photo of  JBL 2235H that is getting its surrounds changed to Ultrasuede material. The voice coil alignment is being adjusted in the photo.

それでは現在作業中のJBL4333B用ネットワークの作業をいくつか紹介します。
I will post my recent progress on the JBL 4333B crossovers that I am working on now.




こちらはオリジナルのアッテネーターと、新品交換後の写真です。
These are photos of the original and new attenuators.


セレクタースイッチおよび背面端子の交換、配線もお終えました。
I have replaced and wired the rotary switches and the binding posts.


作業前の測定時に片方のチャンネルでフィルター特性に異常が見つかりました。原因を探ると、この抵抗が内部で断線していました。
During the frequency testing, a defect has been found in the filter characteristic in one of the channels. This resistor was the problem, as if it seems to be disconnected internally.


左右の特性を合わせるために、両チャンネルともMundorf MResist SUPREMEへ交換しました。パーツによってはこのように壊れていても、音を聴いているうちに慣れてしまって、気が付かないこともあるかもしれませんが、本来のスピーカーの力を発揮するためにはネットワークを含めたオーバーホールをお勧めいたします。
I have changed both channels resistors to Mundorf MResist SUPREME resistors to maintain the sound balance. Depending on which parts are broken, you may not notice it since you have gotten used to the sound, but in order to restore the original potential of the speakers, a full restoration including the crossovers is recommended.